BI’s Article search uses Boolean search capabilities. If you are not familiar with these principles, here are some quick tips.
To search specifically for more than one word, put the search term in quotation marks. For example, “workers compensation”. This will limit your search to that combination of words.
To search for a combination of terms, use quotations and the & symbol. For example, “hurricane” & “loss”.
The U.S. Occupational Safety and Health Administration has published its final rule to revise its eye and face protection standards.
The final rule, which becomes effective on April 25, will revise the requirements for general industry, shipyard employment, marine terminals, longshoring and construction by updating the references to national consensus standards approved by the American National Standards Institute, according to a notice published in the Federal Register on Friday.
The standard published by the institute and the International Safety Equipment Association prescribes the design, performance specifications and marking of safety eye and face products such as goggles and welding helmets, according to the organizations. OSHA's final rule incorporates references to the 2010 version of the standard and deletes references to the 1989 version — the oldest edition of the same standard, according to the notice.
“This new rule will allow employers to continue to follow the existing ANSI standards referenced or allow employers to follow the latest version of the same ANSI/ISEA standard,” OSHA said in the notice. “Employers are not required to update or replace protection devices solely as a result of this rule and may continue to follow their current and usual practices for their eye and face protection. Therefore, this rule has no compliance or economic burdens associated with it.”
OSHA requires employers to ensure that their employees use eye and face protection where necessary to protect them against flying objects, splashes or droplets of hazardous chemicals and other workplace hazards that could injure their eyes and face, according to the notice. The agency's standards state that the protection employers provide must meet specified consensus standards published by the institute or show that the protective devices used are at least as effective as one of the consensus standards.
The final rule also modifies the language in the construction eye and face protection standard to make it more consistent with the general and maritime industry standards, according to the notice. The agency's last update to its eye and face protection requirements in 2009 did not address the construction standard, and commenters had urged OSHA to do so, according to the notice.
The agency said it received no significant objections from commenters to the proposed rule and is adopting the amendments as proposed, according to the notice.
Employers reported more than 10,000 severe injuries in the first year of the U.S. Occupational Safety and Health Administration's revised reporting rule, far short of the number that should have been reported, according to the agency.